Filter Your Results

More...

Showing 1 - 1 of 1 Results

1984 Ford Bronco Ratings, Reviews and Analysis

Safety Ratings and Recalls

Recall Notices

1984 Ford Bronco (8/27/2007)

Campaign Number: 07E064000
Component Name: FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP
Manufacturer: Ford Motor Company
Description: CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
Defect: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.
Corrective Action: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

1984 Ford Bronco (10/2/1984)

Campaign Number: 84V119000
Component Name: FUEL SYSTEM, GASOLINE:CARBURETOR SYSTEM
Manufacturer: Ford Motor Company
Description: THE SECONDARY THROTTLE SHAFT MAY, WITH ACCUMULATED MILEAGE, BECOME CONTAMINATED AND MAY STICK IN A PARTIALLY OPEN POSITION WHILE DRIVING.
Defect: CONSEQUENCE OF DEFECT: THIS STICKING COULD RESULT IN A FASTER SPEED THAN INTENDED, POSSIBLY RESUTLING IN AN ACCIDENT.
Corrective Action: THE PRIMARY TO SECONDARY THROTTLE CLOSURE LINK ON THE CARBURETOR WILL BE REPLACED FREE OF CHARGE.

1984 Ford Bronco (1/7/1984)

Campaign Number: 84V013000
Component Name: FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
Manufacturer: Ford Motor Company
Description: THE CLAMPS ON FLEXIBLE FUEL HOSES CONNECTING THE FUEL PUMP TO THE METAL LINE MAY NOT BE IN THE PROPER POSITION.
Defect:
Corrective Action: THE HOSE CLAMP CONNECTING THE FUEL HOSE TO THE FUEL PUMP WILL BE INSPECTED AND RELOCATED, IF NECESSARY.

1984 Ford Bronco (12/20/1983)

Campaign Number: 83V134000
Component Name: SEAT BELTS:FRONT:ANCHORAGE
Manufacturer: Ford Motor Company
Description: THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".
Defect:
Corrective Action: DEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.